AM.CO.ZA (V6-LABEL/A3) V-Auto A3 Automatic Continuously Sheet Feed (ASF) Label Cutting Machine

A: If the data line is connected to the engraving machine, it can be excluded according to

the following methods:

1,Check whether the serial port and transmission rate are set correctly;

2, if it is a USB cable, please confirm whether the port is correct;

Q: Why is it that after engraving output, one side will be transparent and the other side

will not be transparent?

A: 1, the knife installation is too long, beyond the thickness of the material;

2, the pressure is too small, the normal pressure is more than 200;

3, engraving machine pad blade wear, need to be replaced;

Q: Will small characters below 1CM be deformed?

A: To carve small characters, you need to set sharp corner compensation in the software.

For example, in the Wentai engraving software:

1. Click "Engraving Output" to pop up the engraving output screen;

2, click "Settings", the engraving machine Settings screen appears;

3. Click "Compensation Settings" to pop up the dialog box;

4, select "sharp Angle compensation",

adjust the required value size to achieve the ideal effect.

The compensation value is between 0.1 and 0.7, and the general set value is 0.25. In

addition, the engraving speed of the cutting machine should be set below 100.

Q: Why is there an extra stroke after the inscription?

A: 1, first check whether the cutter head is not flexible;

2, if some words are not normal, please replace the engraving software;

3. Check whether there is any problem with the document.

4, exclude whether the machine is connected with ground.

Q: Why does the engraving output "crash"?

A: 1, When the external 220V input voltage is too low (150V), the lettering machine will

- 21－ AM.CO.ZA / Sales WhatsApp 060 600 6000 / Support WhatsApp 060 600 7000

21